2beornot2bop
Well-known member
Hi all,
I've just acquired Monolith III's yesterday. A nice mint pair in all black arrived from NC to Seattle. Upon viewing JonFo's thread on proper setup I realize I've got my work cut out for me acquiring the knowledge to do proper room measurements etc. There'll be time for that later. For the moment my goal is simply to be able to play some music through them.
The speakers active Exos x-over was sold before I got to them. I've got my eye on a DBX drive rack 260 perhaps. But at this very moment all I have on hand is a Behringer CX3400 Super-X Pro crossover. It will get me by until I'm in the position to obtain a better x-over.
Is there anyone here with experience with this model of the Behringer I've mentioned? The manual flat out leaves a lot to be desired. It's useless to a newbie, and appears to be written for someone whose had years of experience with this sort of thing.
I'm doing a bi-amp configuration. A BAT VK500 will be assigned to the high freq's , and a Threshold T200 to the lows. ML specifies a crossover frequency for the M iii's of 125hz. But how to dial in the Behringer CX3400 to properly separate the low and high frequencies to the amplifiers at this point is beyond me.
Any assistance would be greatly appreciated.
Thanks in advance for any assistance the forum can provide.
Best,
Greg
I've just acquired Monolith III's yesterday. A nice mint pair in all black arrived from NC to Seattle. Upon viewing JonFo's thread on proper setup I realize I've got my work cut out for me acquiring the knowledge to do proper room measurements etc. There'll be time for that later. For the moment my goal is simply to be able to play some music through them.
The speakers active Exos x-over was sold before I got to them. I've got my eye on a DBX drive rack 260 perhaps. But at this very moment all I have on hand is a Behringer CX3400 Super-X Pro crossover. It will get me by until I'm in the position to obtain a better x-over.
Is there anyone here with experience with this model of the Behringer I've mentioned? The manual flat out leaves a lot to be desired. It's useless to a newbie, and appears to be written for someone whose had years of experience with this sort of thing.
I'm doing a bi-amp configuration. A BAT VK500 will be assigned to the high freq's , and a Threshold T200 to the lows. ML specifies a crossover frequency for the M iii's of 125hz. But how to dial in the Behringer CX3400 to properly separate the low and high frequencies to the amplifiers at this point is beyond me.
Any assistance would be greatly appreciated.
Thanks in advance for any assistance the forum can provide.
Best,
Greg