Recent content by SHKnapp

I hope I posted all the necessary photos. I'm happy to post any more if necessary. I really appreciate the help Jonathan and I hope I didn't bombard you with more info than you needed... or offend you by my lack of knowledge with electrical engineering! :)

I'm guessing this is where the high voltage board is getting its ground. One of these is going to the panel junction block and the other is coming from the other side of the step up transformer?

Another branch goes through some coils?, capacitors? and resistors? and connects thru a resistor? to something that the signal is connected to? I can post more detailed photos of this path if it's important.

The ground is a lot more confusing to me. It starts at the binding post and then branchs here One of those goes to the step up transformer?

Yellow signal wire going directly to passive crossover? Then out of the passive crossover to the step up transformer?

Grey Music Sensor wires... leave these alone.

Here's the full board

Here's the schematic that Martin Logan gave me. I'm guessing this is everything that needs to get bypassed so maybe this isn't that helpful

Where I could really use some help is with the ESL crossover bypass. Jonathan, I've studied the schematic for your rebuild but the differences between the wiring on my Aerius are just enough to confuse me. I've got the schematic for the Aerius from ML and I can provide any necessary pics from...

Sorry about that sideways pic.

I got all the easy stuff done! Showered panels Filled in woofer cutout to accommodate slightly larger woofer mount Repaired dings in cabinets Repaired dings in rails Painted cabinets matte black Painted rails gloss white Replaced binding posts on one of the boards. (Keeping one untouched to use...

Rails getting painted to match the white component rack

Back panel removal

Looks like more non-standard black spacer tape.

Not original double stick tape on stators and missing Velcro. Guess these have been worked on at least once.