Recent content by JCollins

Hi all, I am hunting for a faulty control panel that sits on top of the ML BF 210 (i.e. controls volume, tone sweep, frequency cut off etc.) in a plastic housing. I am wanting to replace the plastic housing on one of my BF 210's. Unfortunately, it is not a part that can be purchased by itself...

That is great to hear. I have't gone that far with it all before.

Sold on another site.

Thank you. Great to get your 'real world' experience using Devialet as I had read on some forums, individuals experiencing issues, particularly with the 200 and 400 set ups. I have however just purchased today before seeing your post, Hypex NCore 1200 mono blocks. I was looking to go class A/B...

Hi. Impression 11a owner Central Coast NSW. Just got them, wow! Also have ESL and Vantage (they are for sale). Previously Ascent I so long time ML addict. Great to have a fellow ML ESL owner on the east coast. Good luck with the sale of your ML Vantage. I have unfortunately found it hard...

Thank you for your reply. I have trawled through a lot of different forums online looking for user experiences. It seems that some users experienced issues with the Devialet 200/400 Experts on ESL, however I haven't found much noise/dissatisfaction out there in relation to users experiences with...

I am looking to purchase a new amplifier very soon. There are a few amplifiers of interest. I currently have a NAD M2 and Rogue Audio Cronus Magnum, that I will move on. My room is 17ft x 13ft x 9ft. I am considering a Devialet 220 Expert Pro CI as an all in one solution. There are a few other...

The bottom end with 2 x BF210 will be just fine. ML 13a are not required for the bottom end. It will just come down to the wider ESL panel on the 13a, which I can't really comment on whether it will make much of a difference to the size of the sweet spot, as I haven't compared/contrasted between...

Thank you for your responses. They all make sense. Sounds like even just one AHB2 would likely be sufficient into 4 ohms nominal given my room dimensions 14' x 16' x 9' and listening position at 10' from the front of the speakers. I am still keen to know if anyone has experienced issues with the...

I am considering the purchase of a few different amplifiers. On my amp short list includes: 1. Sanders Magtech - Very powerful, built for ESL speakers, handle very low impedance loads (i.e. 1/3 ohm) with ease, S/N ratio is good at 110 and THD is good. 2. Musical Fidelity M8-700m - Very powerful...

Hi, I have a room circa 14' x 16' x 9' with ML 13a and 2 x ML BF210. While I would definitely benefit from some additional width and depth to the listening room, the set up works well within the room. I have the ML 13a 5' off of the wall from the back of the ESL panel and about 2' off each of...

No, I run a Nad M2, so no Dirac capability. I seriously considered getting a M33 but was advised against it by hifi retailers due to its low amperage output and likelihood of cutting out (protection kicking in) at higher volumes. Would consider a Nad M12 pre amp with Dirac.

I recently purchased some new ML 13a after 10 years with ML Summits. I currently run a Rogue Audio Cronus Magnum integrated valve amp and a Nad M2. The Nad M2 often shuts down at higher listening levels due to its inability to handle the low impedance of the ESL. I am looking at getting a...

Hi all, I have just joined MLO. It's great to be onboard. I became converted to the Martin Logan ESL sound many years ago during my teenage years. I own ML Summits and have just purchased ML 13a. I also have two ML BF 210. I use Rogue Audio valve amplification and NAD Masters Series electronics...