Greetings –
I have noticed quite a few members that have extensive knowledge regarding carpentry thus the question.
I have a media cabinet (actually a sideboard / buffet) that will not accommodate my receiver – it is not deep enough (short about an inch). I was either going to cut out a portion of the back more or less the same size of the receiver. However, I thought maybe it would be better to remove half of the entire back panel (not sure if this is even possible). The idea being if I were to use this unit for it’s intended use, I could somehow reattach the back panel – this would be easier and aesthetically more pleasing than attempting to attach a smaller piece. Not sure which way to go, any thoughts and recommendations would be appreciated.
Thanks.
I have noticed quite a few members that have extensive knowledge regarding carpentry thus the question.
I have a media cabinet (actually a sideboard / buffet) that will not accommodate my receiver – it is not deep enough (short about an inch). I was either going to cut out a portion of the back more or less the same size of the receiver. However, I thought maybe it would be better to remove half of the entire back panel (not sure if this is even possible). The idea being if I were to use this unit for it’s intended use, I could somehow reattach the back panel – this would be easier and aesthetically more pleasing than attempting to attach a smaller piece. Not sure which way to go, any thoughts and recommendations would be appreciated.
Thanks.