eddiegnz1
Member
1) What is the constant DC voltage to the Diaphragm on the Monolith III panel, based on the original factory specification?
2) what is the acceptable range that the diaphragm voltage should be at (for building a DIY transformer set up)?
What I mean by asking two separate questions is that perhaps Martin Logan has it pegged at 5,500 volts DC (for EXAMPLE) but it would work almost as good from 5,300 to 5,700 (for EXAMPLE).
I'm not asking about the step-up ratio to the stators because I'm pretty sure that is a ratio of 1:50.
Kind thanks,
Eddie
2) what is the acceptable range that the diaphragm voltage should be at (for building a DIY transformer set up)?
What I mean by asking two separate questions is that perhaps Martin Logan has it pegged at 5,500 volts DC (for EXAMPLE) but it would work almost as good from 5,300 to 5,700 (for EXAMPLE).
I'm not asking about the step-up ratio to the stators because I'm pretty sure that is a ratio of 1:50.
Kind thanks,
Eddie