Bernard
Well-known member
I removed the electronics boards of my SL3s for some minor surgery to one of the caps, and am now putting them back together. One thing that is causing a devil of a problem (not the first time, either) is putting back into the terminal block the wires to the LED. I just can't seem to get the wires inserted and tightened down. If one goes in okay, the other does not, and it is even more difficult then. I have been tearing my hair out for at least an hour. I know that I will not break anything if I leave the LED disconnected, but the LED is a good indicator when problems arise.
Any thoughts on how best to do this? Perhaps apply some solder to the wires?
Any thoughts on how best to do this? Perhaps apply some solder to the wires?