Hi Guys
After doing a lot of research on the inductors in my Aeons I noticed that two of them were side by side in the same plane. Both were screwed to back board of the cabinet. I removed the non magnetic screw and was able to turn it 90 degrees to the other one. There was enough slack in the wires to be able to do this without putting any strain on them. I used a bit of caulking just to secure them as a temporary measure.
I do feel that this has added a bit more clarity. The best of it is that it is easy to revert to the original configuration. It might be work a try and not a lot of work.
Regards to all
After doing a lot of research on the inductors in my Aeons I noticed that two of them were side by side in the same plane. Both were screwed to back board of the cabinet. I removed the non magnetic screw and was able to turn it 90 degrees to the other one. There was enough slack in the wires to be able to do this without putting any strain on them. I used a bit of caulking just to secure them as a temporary measure.
I do feel that this has added a bit more clarity. The best of it is that it is easy to revert to the original configuration. It might be work a try and not a lot of work.
Regards to all