How to remove ascent i panels

[Paul Pohopien]

wondering if anyone knows how to do this. I would like to perform the "shower technique" as I've done this on other ML speakers with tremendous success. These ascents, however, I'm not sure how the rails even come off?

Anyone know how?

 

[miljac]

You don't need to remove rails to get the panels out.

Just unfasten the screws behind the panel. Unscrew first 4 lower screws on each side, then remove the stator wire cover plate, lay them down on their backs and unscrew the top screws.
Slide the panels upwards an inch or so to reveal the wires, then gently disconnect them. Then you can lift the panels.

Hope this helps

 

[Paul Pohopien]

Sweet...they lifted right out....thanks!

 

[Tony Century House]

One of my Ascent Speaker panel slid down, and noted a broken bottom channel where the stat stop was installed to support the panel. The broken channel was repaired with an epoxy glue, but noted that most of the adhesive foams are no longer effectively holding the panel.
I need some replacement of the adhesive foam. There are 2 sizes, the one that is attached to the panel with back to back adhesive is about 1/4" thick and 1/4" wide, while the ones that is attached to the panel itself is much thinner and smaller. I need help from anyone with the same kind of issue, please send me info regarding replacement foam and where to purchase them. Thank you.