Recent content by Nielsen

You could place them more or less where the plants are on the photo, I think it would work, but its a huge room. What I cant see work is the tv, I wouldnt have it there, its way too high I think. I would maybe try to see how it would work if I put the tv where the picture is hanging, but a bit...

Just look at the specs for Theos and send a mail to Emotiva and ask them maybe?

The reason the amp goes into protection mode is the speakers impedance at 1,3 (or so) ohms at 20.000 hz. Lesser amps will go into protection already after a couple of watts out. Have to admit I thought the Emotiva was more stble, maybe its good with newer ML models. The amp must be stable, thats...

Your Pioneer is a digital amp? I tried a Cary digital amp for my Aeon I, only took me 1 second to decide it didnt work, delivered it back to the shop. The sound was dull, no treble, terrible. The McCormack might do the trick, most important is your power amps input sensitivity, that MUST match...

If you press the cone ever so gently a little bit inwards, and you dont hear a noise the are fine. Well, you can measure the panels you have on the speaker, or what? Why do you doubt? 37" might be effective radiating area, and 40 5/4 is the entire panel.

This might help, use a rubber hammer and tap gently, its real easy. http://www.martinloganowners.com/forum/showthread.php?12584-Martin-Logan-Shower-Cleaning-PDF

Its not the dust thats a problem for electrostaticic speakers really, its the dirt, grease etc. The dust will come off when you play music, but the residue from polution, fire places, smoke etc etc will stick like glue and cannot be vacuumed away. Its a good idea to wash the panels every year or...

Its not in your price range but I have used a Bryston B-100 SST DA with my Aeon I for 6 years now, never had the urge to change. The new SST squared amps are awesome.

Look at the link I gave you, post 4 where he puts the speaker on the table. There you see the wires and if you leave the panel as shown on the picture you should be able to measure on the wires with a multimeter where the are attached to the speaker itself. You dont have to totally remove the...

Did you check the wires? You can probably also measure on the pluss and minus wire to see if they get charge. Maybe I am to used to the vibrant clear sound from ML, I went to listen to a relatively expensive B&W speaker some time ago, huge disappointment, tiny tiny soundfield, closed in and...

No Spike, apologies, I read you post wrong, my bad... But, I wouldnt do that personally, I would use one channel to drive the whole speaker and leave the other channel with nothing to do.

Dont know the price in Italy, but depending on your room size I would suggest the REL T5, if you have quite a big room 2 smaller, less expensive subs would be better than one more expensive.

I think you got it wrong Spike. Vertical biamp is when one amplifier drives one speaker, and the other amp drives the other one. Vertical is superior to Horizontal. This way the amp also pumps out more power since the power supply only does one channel. Stereophile tested, a long time ago, for...

I am against biamping with different amplifiers, but if you do, make sure borh amplifiers have the same gain..... With a Krell 250 I wouldnt biamp at all.

Agreed, unless you have amplifiers with identical pain level matching will be a pain. Go for a single amp, the Krell should do fine yes, or maybe look to Parasound NewClassic series or Emotiva.