Recent content by bk12

I am running a single Velodyne DD-12 with my CLS speakers, and have had a lot of luck with that setup. You can have the Velodyne eq itself to compliment the CLS for a flat frequency response without crossing the CLS over. You can also adjust a "tightness factor", which I have maxed out in my...

Thanks for the diagram!

Hi Greg, Can you post the information on the bias change? What is the downside of running newer panels at the older, higher bias? Thanks!

Good point, and I know they are that sensitive as well. I swapped locations from L-R, and the soundstage moved to the other side, same position in relation to the other speaker. This was one of my first thoughts, but I think the L-R swap with same result makes the positioning option unlikely.

Thanks Roberto. How long do I need to leave the panels unplugged before the inside of the electronics box would be safe to work with?

Hi Guys, I finally found a pair of CLS-I speakers within 5 hours of my place (yea!), so I went and picked them up last night. I bought them as being in fair condition for a set of CLS-1 cosmetically, but was told by the owner (seemed very upfront and honest) that they were perfectly fine...

Hi Guys, Thanks for all of the input! I will keep any eye open for a pair within a drive, or a drive/flight.

Hi All, I have been a lurker on this forum for a while (and registered/posted a few times in the previous forum). I had a question for the forum-I am looking to pick up a set of CLS speakers, but haven't come across anything within a reasonable driving distance (12 hours-I live in Ohio and if...