Search results

I have a Marantz receiver 7011 that doesn’t distort at all Also I’m testing a Hegel 190 and it doesn’t distort, however the base is a bit loud and dry

The ESL distorts when the volume is around mid on primaluna volume dial I took the same amp back to the store and tried it on gold note speakers and I can turn up the volume to the max without distortion The main reason I’m trying to understand what is going on is to figure out if I need to go...

Hi, distortion was mid range to low what do I need to compare with the db meter?

Your setup does not distort at mid volume level? I understand that it will be too loud

It distorts at mid volume on the knob In both triode and ultralinear The amp is new And I took back to the shop and from a gold note speaker all the way up, no distortion

Tried both taps, no difference!

Hi, It’s just the electromotion esl

Hi, I had the primaluna evo 300 to try out with my ESLs for a week, I noticed that the sounds distorts dramatically when having the volume mid way, it’s very loud at the stage, but it got me wondering what is going on, just took the same amp and tried it out with a pair of goldnote speakers and...

Hi, I'm having a bit of challenge setting up my Dynamo 1000 with the ESL so far there is way too many options to do that, I'm using marantz 6007, appreciate if someone would suggest on the below 1-Shall I use LFE or line level on the dynamo?, if line level what is the recommended cut off...

Thanks for the info, but I don't understand the 90-110 degrees part? My back wall is actually 2 inches away from listening spot (small room) 90 degrees would be corners?

the NADs in my region are way over priced, probably in a later upgrade I'll get a power amp to drive the ESLs do you think the Current Feedback Topology that marantz got on the 7007 will be good match with the ESLs?

My new mrx 500 just died while I was doing firmware upgrade, now I'm considering swapping it with either sr7007 or denon 3313 I have esl, c2, fx2 on the way My dealer also got NAD but they seem to be a bit outdated so not sure Any advice ?

I got the esl and fitted the c2 in about 12 cm lower than the TV Got dynamo 1000 had a power amp issue so returned to shop and borrowed an abyss As a matter of fact I'm not impressed by the abyss, wonder of the dynamo is going to be any better? I'm using anthem 500 with this setup What is...

Thanks:) So u think The C will do just fine? For some reason on ML site they only match the C2 with the ESL

Hi, I'm planning on pulling the trigger on ESL, FX2, and either C or C2 the problem is I don't have space for C2 so I would like to have the motion C instead, do you think it will match with the ESL? I'm also planning of using Anthem MRX500 any comments on that? I'm probably going to add...