Recent content by Shaftish

Request is sealed. Not sure if I get the Linkwitz thing? For that I should have a woofer with higher power rating I guess?

Is there a new better option than my original woofers in my Requests? I have tried DSP, driven woofers separatly from my panels but I think my analog filters sound better than the DSP. I use a MiniDSP 2x4 HD. It is okey for the woofers but the panels sound so so boring when the dsp is running...

Hi DanR, I can´t seem to find the discussion you are refering to. May I ask what wooer you choosed and why? Do you think that there is better suited woofer out there to my Request? Regarding DSP, I have tried 2 and they don´t sound all that good throu the panel. I think they are doing a good...

Late reply. Yes, they helped me with my Request. They did a fine job, have zero complains.

I have now connected a dsp and one more amp for the woofers. I haven´t done anything with the passiv filter. Seems like a long way back if I don´t like the end result. Or is it worth it? Or shold I just disconnect woofer filter? I understand that there is were the big benefit is, or am I´m...

I´m thinking of do a semi active solution on my ReQuest´s. Just do the bas. Since ReQuest have bi-wire/amp connections a guess that I don´t have do anything else than connect bass driver to bass connections? Seems like a quick job.

So, I found a company in Germany called Hifi-Zenit. They have rebuilt my panels, new mylar and everything. They rebuilt the crossovers as well, they changed the slope on the woofer, se link for more information. ReeQuest have been playing for a coulpe of hours now and they finally sound good...

I have been in contact with them. Quite a big job, building a rig and all. I'm not sure how good it will actually be, is it possible to get the correct tension and precision?

What does arcing mean?

Bad luck haha, naturally it is the wire that I can´t get to haha. Yes, they have used double sided adhesive. After I have written with the ESL rebuild company in Australia I figured that there is a very high risk separating the panel, over 50% chans of failure. But as it is right now it can´t be...

Is this the red wire going to the Mylar? How do I know what type of connection I have?

The problem follows the panel.

Good idea, that played almost an hour before it went silent and about 30 minutes before the interference accorded. I'll make an account on DIY 👍 But I will wash it tomorrow, and dry it with compressed air.

I did. It was working just fine untill this interference showed up. Anyone who can translate the wierd noice, is it dirt related?

I will try to clean them again tomorrow. Maybe I'll get lucky 🙂