Recent content by mikebecerr1258

JonFo... as I get ready to hook up the ML Monolith III... I am throwing the original passive XO's in the garbage. I am hooking up two separate stereo amps that are being fed from the new active XO. Can I hook up one amp direct to the "high"(Electrostatic Panel) jacks on each speaker and the 2nd...

JonFo - need your advice once again. In an earlier thread I believe you discussed your research on the best active XO frequencies was at a minimum 330 Hz for the ESL to switch over to the 12" woofer. In the thread or snapshot above, you mention the high pass/low pass @ 300 Hz. I need your honest...

JonFo... was wondering if it makes any sense to connect the SVS Subs to the Rotel Preamp via XLR cables instead of RCA (each "run" is approx. 20-25'). The curveball to this is that although the Rotel has an XLR output, the SVS Subs only accept RCA input connections... thus I would have to place...

Sorry, but I do not (2nd owner)... so not wanting/able to ship. Can deliver or exchange within 50-75 mile radius. Would consider a further distance, depending on circumstances...

Parma, OH 44129

Unfortunately No! I have just REDUCED to $1,050.00!!!

Okay... If I wire it per your Note from yesterday, then please confirm that wiring from the K231 Mid to the Amp that drives the Woofer, then in fact now makes the Woofer into a Mid-Range frequency reproducing speaker, since the XO modules are set at 300Hz & 80 Hz (Above 300Hz are sent to the...

Okay... I am going to run ALL unbalanced RCA connections for the 3 frequency ranges - Going from the Rotel L/R to the K231... and then out from the K231 High to the amp that powers the Panels, and out from the K231 Mid to the amp that powers the Woofers (which means the existing Monolith woofers...

Hello All... wondering if anyone has knowledge or experience with replacing OEM logo light modules on the Odysseys? Until very recently, both speakers had functioning logo lights, although both were very dim when lit. Strangely, both lights burned? out at the same time and are no longer...

Hello Jonathan!!! I have 3 final questions to ask of you regarding this super-long thread. Initially, let me confirm the arrival of both the Rotel RSP-1582 Preamp/Processor AND the Sublime Acoustics K231 3-Way Active Crossover... although I can't comment yet on them due to the fact they have yet...

Hello… I just saw this message yesterday! I can provide you with my cellphone number if you’re still interested. Then I can text you numerous pics of the Odyssey’s! Thanks!!!

I just tried to follow your directions... hopefully I will get a response! Thank you for your assistance...

How do you go about sending a PM???