Search results

Going to be a while, as the maggies are backordered - 4 weeks or so but then I will let you know how it sounds (about 100 hours to burn in, I believe)

I like the way mine runs and rides but I'm not a high speeder - too many tickets in the past to do that - I don't do twisties at speed anymore - the reactions just aren't that good. Last run I did was up to PA then down to FL and back here - around 4,500 miles split between 60% back roads and...

I agree - finally got with ML and through trial and error, the culprit turned out to be the servo within one of the speakers (no, I never heard a speaker hum when it was not induced by the amp or the wire but they were familiar with this trait). Thanks again to all.

The hum Thanks for all the input! Looks like it is a defect, so I will be pursuing with ML. Greg

many thanks

Your gathering Sounds good but I am up to my eyeballs at Dell for the next few weeks. Noted your a biker in your posting? Ditto running a Kawi Concours 14 Greg

The hum could not find another power cable - the one supplied does not have ground, so I will need to go out and find another but I did try several outlets with no difference noted.

Descent i hum The hum is there even with nothing except the power cord hooked up; I tried a ground lift and it did nada. I hooked in the line in and, until I attached the other end to the pre-out on the amp, the hum was perhaps 80% reduced but once I attached to the amp, it worsened. Ordered...

Just fired up the Descent i sub today and noted a (60 cycle?) hum. This is unchanged whether or not anything is hooked up and is unaffected by the volume control. Have not been able to get to service and am at a loss. Any ideas out there? Thanks! Greg

Just got my first piece of ML equipment - re-doing a 25 year old system and replacing BEL, Klipschorns & Audio Research with ML (Descent i) Magnepan 1.7's & a Krell. Looking forward to learning on this forum.