Still do not have blue light. The blue logo is flashing about 3 seconds When The speakers connect to power and after 3 seconds are just dark. I'll send this power boards to ML think...
the red led is working on power board when I plug in the 220v power wire just for few seconds . And when I pressed the bypass test switch than tester diode working but is not stability is (dim)
No, blue Led is not working at all just small Led connect directly to Led out on the Power Board is dim. But only when I push in the switch on Power board by myself.
Hi,
I found another difference on the power board, perhaps that affect blue logo light wich is not display... can u guys make good quality picture Odyssey power board, or tell me what resistor is there?
That switch SX2 doesn't work automatically just working by manual and that even is not enough power for blue light.
You have a right it can be dirty. I have to check all the options ...
Just thinking do I should use different amplifier ? Accuphase P-300 working in 4-8 Ohm but Odyssey working even in 1 Ohm sometimes. Not sure or that is good for old Accuphase. That amp has new electrolytic capacitors but still I have worries.
Small change in the system. Step by step right true dream Neolith :rolleyes:
ML Odyssey
Accuphase P-300
Accuphase C-200
Accuphase T-100
Onkyo DX-7711( transport for DAC )
Tube Output DAC
smal bulb (LED)
yes CONX4
I think some resistor or diode is gone. Stators are also not disconnect selves after turned off the amp...
maybe I'm wrong but after amp turned off I can hear in the bottom part the panel gently noise. After music on the panels start working after maybe 2...