Recent content by majin tcz

I just unplugged the speaker to move it from its location due to having my floor redone. I moved it back and now there is a high pitched noise coming from it as soon as it gets power. I’m not sure why it’s happening or how to fix it.

I need help. One of my Purity's signal light is switching from red to blue (mostly red) continuously. While its red I can hear a very low volume of whatever signal I send to it. Then it will switch to blue and get a full volume regular signal, then after like 10-15 seconds switch back to red...

Hey everyone, I know asking about what amp to buy is the most asked question on this forum. I apologize in advance. I'm finally separating my video components from my audio. I have a pair of Theos that had been previously powered by a Yamaha receiver and I'm looking to move to separates or...

I have the original dynamo. I have the lfe and interconnects hooked up from the preouts of the receiver to the sub.

Ok so just to clarify, Since my global crossover in my receiver is at 80hz for all speakers set to small (which is want I want even though martin logan says otherwise in the video?) For music in pure direct on my yamaha I still am supposed to have the lpf on the back of my sub set to maximum...

Thats true that in pure direct that it only sends a 2.0 signal. But while in pure direct the preouts on the receiver send a signal to the sub. Which is why I was wondering on what position to set the LPF on the back of the sub. Should it be 80hz since the crossover in the receiver is set to...

Hello everyone, I didn't want to start a new thread but I'm slightly confused on setting up my sub. From what I understand I should have all my speakers set to small to send the bass to the sub. The crossover in my Yamaha RX-V1900 has a global crossover setting that effects all the speakers...