Recent content by kilbowie54

Finally obtained a replacement power supply board from the UK distributor. Cost £228 including all taxes. ($369 US at current exchange rate). Board is slightly different from the original one installed - connector pins 3 & 4 on the new board are in slightly different locations and I'd have had...

Thanks to everyone for their comments and help. I think I'll try and swap over the power supply boards between the "good" and "faulty" speaker Sunday, when I've time. I'll need to remove the board anyway when the replacement I ordered from the UK distributor eventually arrives and it'll be good...

The bad speaker isn't completely dead - there is a little sound from the stat panel but it's at a very low level. Woofer and NEC driver seem OK. I didn't swap the power supply boards between the good and bad speakers because I wasn't sure how to go about this. I did remove the speaker base to...

Thanks for replying. Scott at Martin Logan sent me instructions for swapping the stat panels between the two speakers to check them. I hope it is the power supply because I've ordered one from the UK distributor in London. No idea of cost! When I connect the faulty speaker to the mains power...

Hi, I'm in the UK and new to this forum. I've owned a pair of Clarity speakers since 2006 and they worked flawlessly until 2 weeks ago. I had disconnected them to re-decorate my listening room. When that was completed, I placed both speakers on their sides on a thick rug to screw in the spikes...