Margin Logan Request impedance question

MartinLogan Audio Owners Forum

Help Support MartinLogan Audio Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
S

sonicPenguin

New member
Joined
Aug 21, 2009
Messages
1
Reaction score
0
Location
USA
Hi there.

I recently got two NAD 218 THX power amplifiers that I wanted to use to drive my newish to me Requests.

I am planning to bridge them and use them as monoblocks.

I am concerned that the back readout of the NAD 218 connectors
seems to say something about bridge mode only proving 8-16ohms
output?

Does this mean I cannot use these lovelies with my Requests to
get a bit of extra omph?

Its my understanding that the Requests are 4ohm?

Any advice anyone can offer?
 
You would be better off using them without bridging and bi-amp instead, this way they would not have a problem with the load and probably give you better results.
 
Yep, that would be my suggestion too. That's what I used to do when I had my ReQuests. Of course you'll need an extra set of speaker cables.
 
You must log in or register to reply here.

Similar threads

J
Benchmark AHB2 Bridged Monoblocks -
Replies
12
Views
4K
SKY888
S
kzs70
Center speaker question - Motif or Stage?
Replies
4
Views
836
kzs70
kzs70
A
ML Electromotion ESL and bridged Parasound A23
Replies
7
Views
3K
ankan
A
C
Martin Logan Trainer & Set-Up Expert Joel Lopez - "It's My Passion"
Replies
8
Views
4K
Duke
D
C.A.P
The Story of an EAR-diophile ... and the humor and insanity ! (long fun read)
2 3
Replies
42
Views
5K
bonzo
B

Latest posts

Back
Top