Custom Search
+ Reply to Thread
Results 1 to 7 of 7

Thread: Center channel idea

  1. #1

    Default Center channel idea

    i recently heard the theater i in a dedicated theater and was not all that impresses. low level volumes lacked in the particular setup, even using a krell amp. what i though is to use say a pair of scripts horizontally as a center channel powering it with either 2 separate channels or using 1 channel bi-wired (each run goes to each speaker). is this a bad idea? will the performance be any better... since i love vocals in 2 channel mode. any suggestions? thanks everyone.

  2. #2

    Default

    Most of the times, the center channel is very badly set up... The dispersion of the Theater is superior of that of two Scripts, because of its tweeter array. I would not go the route of double Scripts.

  3. #3
    Bonedust
    Guest

    Default

    just because it had krell power on it doesnt mean the center is a bad choice. i have a theater i with an fbp350mcx on it and the sound is stunning.

    i experimented with the script center idea about a year ago. heres what i found:

    1. the sound was very good, but EXTREMELY localized....like unless u sat dead center in the room, the results were poor.

    2. the 2 panels put so close together seemed to have a back wave phase problem. i even tried a damping panel on the back sides...still heard a 'hole' in the sound.


    hope that helps, but dont give up faith in the Theater yet...have a listen some place else.

  4. #4

    Default

    actually, i like krell amps very much so i was surprised that it didn't sound good. that was what i meant in my original post. if you tried the script idea already, then i will drop the idea completely. thanks for your experience.

  5. #5
    Kevin
    Guest

    Default

    The theater i is a poor performing speaker which caused my to trade it in. The best thing for ML to do is use an ascent i panel and go from there.

  6. #6
    Bonedust
    Guest

    Default

    Quote Originally Posted by Kevin
    The theater i is a poor performing speaker which caused my to trade it in. The best thing for ML to do is use an ascent i panel and go from there.
    it may have been poor for your application. however, it is far from poor.

  7. #7
    Kevin
    Guest

    Default

    it may have been poor for your application. however, it is far from poor.
    In a home theater system 80% of the signal is sent to the center channel. With that much demand being put on the center channel the theater i did not perform to the ML standard of performance. So I went out and purchased a Mcintosh XR27 which does the job perfectly.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts