RichVFR
Member
I'm also considering replacing the 10mH inductors in series with the woofers in my ML ReQuests. I suspect they are over 1 ohm DC resistance. I have my eye on the Jantzen 10mH 14 AWG C-Coil Toroidal Inductors are available on Amazon that have about 0.1 ohms DC resistance.
Making this change should produce a little more volume from the woofer, tighten the grip of the amp on the woofer, change the total Q of the sealed box alignment for less ringing and hopefully improve the sound and definition available from the woofer. But I'm concerned that the design of the resistor/inductor/capacitor filter that is in parallel with the woofer would be thrown off by this change. Has anyone tried this? Any recommendations/thoughts? Thanks!
Making this change should produce a little more volume from the woofer, tighten the grip of the amp on the woofer, change the total Q of the sealed box alignment for less ringing and hopefully improve the sound and definition available from the woofer. But I'm concerned that the design of the resistor/inductor/capacitor filter that is in parallel with the woofer would be thrown off by this change. Has anyone tried this? Any recommendations/thoughts? Thanks!