Hi there,
just joined to this forum, hello to everybody and let's start with my first discussion and question:
I own a pair of SL3 since...years, they are driven by a Proceed AMP2 using a biwirng Kimber 8TC cables (two pair of 8TC) and sound simply wonderful, but....there's always something to do....
I'm thinking to duplicate my AMP2 to try to biamp the logans
Maybe I can set the two AMP's as bridged mono units just doubling the power and still using the biwirng connection, or I can try to vertical or horizontal biamp them, but I'm little worried by the channels used to drive the panels only, because of the risk of a very low minimum load.......
Does anyone have experience with this stuff? any opinion or tip?
Cheers
Paul
just joined to this forum, hello to everybody and let's start with my first discussion and question:
I own a pair of SL3 since...years, they are driven by a Proceed AMP2 using a biwirng Kimber 8TC cables (two pair of 8TC) and sound simply wonderful, but....there's always something to do....
I'm thinking to duplicate my AMP2 to try to biamp the logans
Maybe I can set the two AMP's as bridged mono units just doubling the power and still using the biwirng connection, or I can try to vertical or horizontal biamp them, but I'm little worried by the channels used to drive the panels only, because of the risk of a very low minimum load.......
Does anyone have experience with this stuff? any opinion or tip?
Cheers
Paul