Turntable Question

MartinLogan Audio Owners Forum

Help Support MartinLogan Audio Owners Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

jtwrace

Well-known member
Joined
Sep 28, 2006
Messages
1,101
Reaction score
0
Location
XXX
What is the size (diameter) of the stud on a turntable? I'm going to make a clamp and want to make absolutely sure that everybody seems to have the same size. They are the same size but I'm more concerned with the tolerance that certain company's use. So, if you don't mind giving me yours (using a veneer caliper) that would be great. I will make a one pounder to start with.

Who is the turntable guru in this bunch???
 
Rega Planar 3: 7.1 - 7.2 mm
This was difficult to measure because the spindle is tapered, so I am afraid it was difficult to get a more accurate and consistent measurement with my calipers, but it appears to be 7.2mm at its widest point.
 
My caliper is up in the garage. I'll report in tomorrow.
 
9/32 of an inch (.2805), on my VPI Aries 3, basically the same as Dan's measurement of 7.1 mm.
 
Last edited:

Latest posts

Back
Top